Abus-technologies A4000 Series Universal Controller Manuel d'utilisateur télécharger pdf (Page 12)

ABUS TECHNOLOGIES INC.

A4000

7.4 Additional Notes

7.4.1 Additional A4000/A4000 16-bit input signal selection

7.4.2 Additional notes of manipulate operator/ electronic-machine driver.

1. When the adjustor is a non-electronic machine control output, all key operations are the

same as stated before.

2. When the adjustor is non-electronic machine (required the electronic machine driver must

have Low-High location equipment.) control output, some parameters should be modified as

follows:

HY: Blind spot of motor control setting. Range: 1.0-5.0%

Ct: The running time of full open to full close to full open. Range: 20-250 seconds.

AL1: Normal alarm mode.

OUTL: Value output law value. Range: 0.0 ~ 50.0%.

AL2: Change to motor positive-tune control.

OUTH: Value output high value. Range: 30.0 ~ 100.0%

OUT: Motor reverse-turn control.

3. Displaying operations:

 PV displays the measuring value.

 SV lamp on displaying preset value, SV lamp flashes displaying value feedback value,

MV lamp on displaying control output value.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Abus-technologies A4000 Series Universal Controller Manuel d'utilisateur Page 12